Latest activity

2025-08-10 Convert Heater Blower Resistor Card into PWM controller Recently noticed the battery is again not fully charging up towards...

2025-07-04 Shorten Bonnet Hook The bonnet seems to sit slightly too far up and the latch is already at it's lowest position, so the...

Personal Update 2025-08-17 It's been a difficult 2025 for me with no signs of hope 😞 Left a terribly uncomfortable & brief job in...

Ive got a 2002 k11. Theres a lot of rattling coming from the timing chain, 83k miles on the clock. What is the recommended milage to...

Having read this i dont think ill attempt it myself. Ill get a price off a local garage, but tbh if the chain goes its 100 quid for...

I have always DIY maintained & done MOT repairs for 51 years as a cost saving hobby interest on my old bangers. Buying a mig welder...

Hi Regards type of welder, gas or gasless, single phase 13amp or 3 phase. The gas is better for bodywork. The small gas bottles are...

Hello I'm looking for a single or the full set of 4 alloys. I'm ok with average condition as long it's still straight. thanks

Hi Regards type of welder, gas or gasless, single phase 13amp or 3 phase. The gas is better for bodywork. The small gas bottles are...

If it's the same area I had to do photos are within my posts. Just bent metal to shape and cut out the rust. I think only outer sills...

The GREY wire is the ground. Black is signal.

Hello. I would be interested to hear what is the opinions of members who have a mig welder, model make and how it performs on thin body...

Hello, I am looking for a good Nissan micra. I live on the Shetland isles so to visit and view I will have to come over on the ferry to...

Although I have no experience in doing that sort of repair, I think your idea to use the body panel from another K11 to replace the...

Hello, I have a k11 in very good condition but I have discovered that part of the body behind the sill in front of the off side back...