odd as it may be my selector shaft if totally different to that, after taking the boot off i couldn't not find and roll pin. im going toward the chop and weld route. unless of course the k11 one fits 'perfectly'?
the support shaft..if i cut and shut the old k10 mount to support the mount, that should in theory work right?
another thing was, after getting the missing mount, the upper most bolt refused to line up which i still cant understand. before i put the 3 bolts in (well 2 fit ) it lines up dead center and as soon as you start putting the bolts in it wavers out. should be strong enough on 2 bolts though i hope.
i wish this whole swap was more efficient, currently its taken about 16 man hours! and its still not done. :down: got to keep trying though, i refuse to sell it even though thats the advice of family members.
