• Please only use these forums for blogs, they are not a discussion forum

Reply to thread

If someone here had told me hammer part that will bend not the cv-joint itself, (angled part) this would have saved an hour or more time.


Left cv-joint presumably original and perhaps fubar because really 80% also vibrate away. The hint in difference, not measured but was good, but the hint is conical - conical tone. Solution was replace both cv-joint still price attractively low


Ringing and hammering by me and with help asking ringlet beating by mechanic with 20 years of experience. No, they will indeed not go back into it. Where the pieces have gone, I hope jumped out but this was not visible. Cover closed and ready.


This ring fit fine and was  a 1 hour CV joint (proper) mounted action and that included getting the air tool compressor and everything tiedied up.


Replaced wiper rod for used with knowledge that it was good. Don't want to work properly yet :(


Also some tectylation


No more pain and problem


Back
Top