Reply to thread

The guide would be right except the live that you use for the clock, use for the rev.


Simply get both the dials and check were each set run to and check against the wiring configuration on each. If one needs moving, move it.


you can tell by looking at the run, were each one goes to and which are earths etc. simple jot down each one.

go to the super S and see which slot each go to. then transfer the wires to there.


You may require another plug, from super S as i believe some were different.


But it means you may require to do some working out yourself. the Haynes will tell you what wiring it is. except it wont tell you how to swap dials, as this is NOT what it is for, but it does give the wiring.


Back
Top