Electromagnetic bushes

[kwkevy]

Hi does anybody know what symptoms this would produce

 

[Micra Paul]

Hi does anybody know what symptoms this would produce

I suspect that you may have found the fault source of the Kangaroo intermittent drive issues with the auto CVT?

AS always do your own research read through the following links & don't overlook the Similar threads at the the bottom of each MSC page.

K11 CVT Automatic Carbon Brushes Faults at DuckDuckGo

Good luck.

 

[kwkevy]

Have cleaned them up, the short one was jammed and now moves on its spring . Noticed it was about 10 mm shorter than the other still . Put them back in (doh didn't check the wear limit but pretty sure there were none ) would it have worn past them ? . Had a slight improvement. Considering the amount of crud on the do you think the electromagnetic powder could be contaminated?
Thanks Kevin

 

[Micra Paul]

Have cleaned them up, the short one was jammed and now moves on its spring . Noticed it was about 10 mm shorter than the other still . Put them back in (doh didn't check the wear limit but pretty sure there were none ) would it have worn past them ? . Had a slight improvement. Considering the amount of crud on the do you think the electromagnetic powder could be contaminated?
Thanks Kevin

Unlikely from the carbon brushes?

 

[kwkevy]

Phew thanks. Will whip them out again and check the wear limit

 

[kwkevy]

Is that the limit line on the left one ?

 

[kwkevy]

Anyone used these ?