• Please only use these forums for blogs, they are not a discussion forum

Reply to thread

Well the trailing arms arrived and as expected they needed modding

The two bottom arms the handbrake mount was in the middle so chopped them off and welded the originals a little further down like the originals were and the top n/a didn't have a brake balance atm so welded the old one onto that

Noticed tho there's quite a few k11 spares that are fairly different to the original ,some to the point were they don't fit like how the should,

anyways going to spray the hubs and wishbones , then strip down. The struts and coils, and anti roll bars ,back plates etc and see if I can get the rear axle shot blasted

Then sort the o/s sill, finish to bits in the front wheel arch and tidy the front end up , and strip the main floor pan, as Well as two bits under the back seat ,then prime i think and paint yellow :)

And get some new bolts as I chopped half of the trailing arm off lol


Back
Top