Search results

  1. Mach1

    Suspension system.

    Tool looks ok, remember the inner rods will be tight. I have recently removed my rack for a complete refurbishment, as I had removed lower sub frame to renew the bushes with was causing a banging sound from the passenger side, but turned out to be drivers(RH side) which was U/s so must have been...
  2. Mach1

    Air con hot and cold, please help.

    could be an air valve mix actuator or sticking flaps, I cannot tell from your description if the air con is manual control or climate control (Automatic) which if it is the latter is controlled its soley by it's own circuitry?
  3. Mach1

    roof rack for 3 door K12

    I have seen this roof rack on ebay, not cheap but are for the 3 door micra, I may get one myself for my long journey to Spain in september. https://www.ebay.co.uk/itm/133884083238
  4. Mach1

    A auto not shifting into 4th.

    I would check the Auto box fluid level, this is typical of low fluid either from a seal leak or maybe the gearbox needs flushing and refilling with fresh hydraulic fluid, these gearboxes tend to be overlooked when serviced.:unsure:
  5. Mach1

    Passenger window won't work

    Check the power at the motor contacts at same time as pressing the window button to check if voltage is reaching the motor, if so, look for a replacement, or if no voltage check for broken wires from the switch to the motor?:unsure:
  6. Mach1

    Hi has anyone swapped a the main fuse box located under N/S headlight is it just a straight swap

    I cannot see a major problem, once the battery is removed, fuses and relays generally don't require coding only electrical devices that are plugged into the cars cpu will need this, dont forget to photo your progress to refer back if you get stuck.
  7. Mach1

    After how many km should one change the pollen filter?

    10,000 Km (6200 miles) is not the distance that you generally require a pollen filter change unless you live in the part of the world that warrants it! how long in time has it been since the change? generally when servicing any parts of the car it is usually on mileage or time lapse since the...
  8. Mach1

    Crank sensor?

    Don't rely on error codes all the time, I had no error faults and engine was hard to start when cold, but 3 of the 4 glow plugs were burnt out, also alternator was not charging battery fully. the E10 fuel can also cause starting and stalling issues.
  9. Mach1

    Crank sensor?

    I think you are refering to a petrol version when you mention a timing chain, there was an early fault with low tensile chain links fitted to some models which stretched, and can show up as a crank sensor fault, first change your spark plugs and air filter and put a benzine additive in to the...
  10. Mach1

    Micra k12 buyers guide/advice?

    Personal choice and again the condition of the vehicles both in terms of body/engine and also maintenance history is a good way to go, for smiles all round the Sr160 will win over, but again Condition is paramount or you will be buying a money pit and the inconvenience of sorting out. Average...
  11. Mach1

    Hi has anyone swapped a the main fuse box located under N/S headlight is it just a straight swap

    The lid on the fuse box containes all the fuses and holders the lower part is just a box to seal the fuses from the elements, It should be a straight forward job but take photos of the parts and wires as you dismantle to help with installation.:unsure:
  12. Mach1

    Install a sat nav unit from a 2010 K12 to a 2005 K12

    I have found a k12 micra sat-nav with air vent surround so should be a good replacement to upgrade. https://www.ebay.co.uk/itm/393865964746
  13. Mach1

    Unable to open driver door from inside

    You may have to go in further I had a similar problem and the nylon guide that connects the steel actuator rod to the lock/unlock mechanism had broken. If your mechanisms seems ok then maybe a new lock is needed. As with everything on older cars sometimes you have to delve deeper to sort out...
  14. Mach1

    Heavy steering and reluctant to return re-centre steering wheel

    If the ps light goes out when you start up, then it's possible that the cpu has checked the system as ok, however I still believe untill you check the steering mechanics first and renew what needs to be changed you will not have a clear idea. K12's are great when you know them, buying a good one...
  15. Mach1

    Heavy steering and reluctant to return re-centre steering wheel

    Yes the UJ lives in the car foot well and is shielded from the elements, the main steering rack lives on top of the front subframe and which is protected from the elements by a plastic splash guard that covers from the front of the car to the rear of the subframe. I have just refurbished my...
  16. Mach1

    Heavy steering and reluctant to return re-centre steering wheel

    Steering column shafts on the K12 are designed for greater range of movement on their shafts than other makes of cars, due to allowing enough play to lower and unbolt from the lower subframe and then be reattached when reassemble of the subframe is undertaken. tight steering knuckles like on my...
  17. Mach1

    Heavy steering and reluctant to return re-centre steering wheel

    I use European parts when ever I can, here is a link to Meyle wishbones with a 10% reduction in price at the moment: https://www.ebay.co.uk/itm/152223873203 Also a video link to help: The outer track rod ends are easy to replace for peace of mind.:)
  18. Mach1

    Heavy steering and reluctant to return re-centre steering wheel

    Check the lower ball joints on lower wishbones, they tend to be overlooked and are easy to replace and tend to become stiff even if not worn when car suffers lack of use. spares for lower wishbones are:54500 - AX600 & 54501-AX600, these parts are cheap enough and not long to change.:unsure:
  19. Mach1

    annoying rattles from the back

    some testers are more vigourous than others, as you say it would need a rolling road on the back to detect a no load rattle. mine passed with rear bearings shot and leaking grease onto shoes so MOT test is not infallible!:unsure:
  20. Mach1

    dCi oil pressure light

    5W30 is what I use in my Diesel, with regards to the oil filter as this is inverted when the engine is stopped the anti drain filter stops oil draining back into the sump, this is ok,as this particular 1.5 Diesel engine has been in production since early 2000's and is used in many Renault...
Back
Top