Search results

as far as i know the mileage is determined by the ECM on cars with electronic odometer, so if the speedo has been changed, or disconnected then the ECM should send the 'correct' mileage to the odometer clock when reconnected. I ve seen it happen on a (DLA) mazda 3 supposed to have 9k when sent...

You're likely to have brake disc warp, brake pads sticking on the sliding surface or sticking slide pins for the caliper. if they are newly fitted discs/ pads, I would check all the mating surfaces are clean and free of any rusty lumps, especially the hub and the brake pad mounting slides.

I take it from your posting the radio is a standard nissan one; I am also assuming nissan fitted rear speakers as standard on the top of the range micra (my 1.3 micra inspiration didn't), cos the low spec ones didn't have rear speakers, if they are in the rear doors the fault could be in the...

It will fail MOT without the resevoir cap, not only for the obvious spillage problem, but the brake fluid will absorb moisture and give you a spongy pedal! Go to a scrappy and whip one off a scrapped one, as they obviously will cost a silly price from your friendly nissan stealer if they can get...

So would I. Nissan recommends 165/60 R 14 77H, and as the 60 erpresents a % of the width(165); if you fitted wider ones the sidewall ratio would need to be smaller, eg... going from 165/60R14 to 185/55 R14 I done this on a tire comparison site: Tire Size Comparison SpecificationSidewall...

Sorry for getting carried away with the bile against the rozzers, lads, the fuzz around here are so petty, they would even leave the dead cheesed off

This is the goverment law ammendment regarding import vehicles and non UK spec plates: The Road Vehicles (Display of Registration Marks) (Amendment) Regulations 2002 (No. 2687)

man, you're enomomy must have been bad to start with! my k11 had a fairly large hole behind the back box, and it dropped approx 10mpg down to about 35mpg, the straight pipe would only be the same as NO silencer, and it maybe an attraction to the pigs for noise pollution.

As i said before, I was done for a similar thing, fined, had to get new plates made, fitted, and then take the car to the Rozzers station in Ballymena to show it had been done to the fcuker who fined me!

Its your licence mate, if you can afford to chance an extra 3 points Just wait unitl the local ####s are wanting to boost their targets or want to get their stripes, especially traffic branch (Road Policing Unit)! those b'stards would do their own mum for a bald wheel on a shopping trolley

Thats what I was thinking.......

haha, that'll fcuk them up if the sh17 hits the fan, cos they should know better!

I know, the Jap spec plate looks the business! That's why my celica has them fitted (but then again its a JDM import) Rozzers argued the plates wern't legal until I was able to tell hem to check the law on registration of used imports, and that ####ed them off Anyone with a query on uk srec...

wtf...........lmao

Yep, technically they're illegal although the digits and spacing are correct, and I'm surprised the MOT centre didn't make you fit the correct ones, i've had cars turned down for the garage logo at the bottom being too close to the digits, and minor cracks in no plate! The only thing you're...

Sorry for the double post, as far as I know halfrauds do the square truck type plate, but you will need the registration certificate and photo ID (preferably drivers licence cos some of their staff can be very thick)

These type of traders are operating illegally! Anyone purchasing Plates must show their Drivers lic and Reg Certificate, its to counteract cloning plates and if they're caught its a £2500 fine, and if your plates are not to DVLA standard you get £60 and 3 points minimum (from the rozzers), next...

Frank, looking at the wiring diagram on autodata, there is 1 feed wire to the ICM and 1 returning. Is it possible to put a 'link' in to bypass the ICM

Not sure where its located on a micra lad, try behind the glovebox, or below the centre console, that's where they are commonly located in most cars. I had a problem with a starlet ECU and had to go back to the scrappy for the Immobiliser Control Module as the code for the Transponder in the...

Seems to be a weak point on the K11, Ext Fuz box melting and Headlamp connector melting, Mine also had the same faults, and a lot of the scrappers I looked at for a donor fusebox were the same!