Search results

  1. C

    Parts For Sale

    OK 0427949935
  2. C

    Parts For Sale

    Will take rear hatch handle if it has "gasket" mould thingy & gasket set :) seeing as I have your hatch,Lhs guard & bonnet!
  3. C

    If comfort and low NVH were the crieria.

    +1 You'll soon get tired of that.. "Please not an Avalon....."
  4. C

    If comfort and low NVH were the crieria.

    4th Gen. Liberty wagon not 3l 6 cyl. too thirsty ? Gen. 5 too fat!
  5. C

    throttle body

    Outlet of throttle body Justin gasket between T/B and manifold. GA15 has outlet of 50mm. Looks the same all in one. If you look down the throat with a torch you might be able to guestimate ... but you'd need a graduated eyeball :)
  6. C

    Wrecking: Modified Red LX

    Is the rear hatch handle ok? I just need the thin rubber gasket that goes under the handle. But will buy the whole handle.
  7. C

    FS: JDM tail lights, Super S dash & bumpers, Panhard rod + more

    I'll take the ECU talk cable.
  8. C

    Shift load of parts in Brisbane

    I will take your wheels :)bank transfer or COD ?
  9. C

    ghetto turbo build page 3

    Good work Frank :) amazing it passed !
  10. C

    2013 ****box Rally fundraising for the Cancer Council

    +1 Done Diagnosed with a tumor myself 3mths. ago ..glad it's only affects my brain which may explain a bit. LOL Go Tyrie
  11. C

    My new L.

    Nice Mark, what size rims/offset are those?
  12. C

    Hurricane 4-2-1 extractors CG13DE

    Dito...do these fit A/C ...
  13. C

    Please Help!

    Jay may only need a set of seals in master cyl. or at worst they can resleeve in stainless. Input shaft bearing is maybe only a $30 ? part labour ..$$$$
  14. C

    wishbones

    And I'm way slow at typing. lol. big hammer can do some damage.
  15. C

    replace antenna

    Yes you have to remove the A pillar trim inside & trace the coax through. It is covered in a thin spungey foam and I think some tape or clips .Tape on some string/wire as Frank says other wise very hard to get back down. I had to use a N14 Pulsar one (telescopic type) and slightly redrill the 2...
  16. C

    wishbones

    Pierce just got some of these pressed http://www.ebay.com.au/itm/2-FRONT-LOWER-BALL-JOINT-NISSAN-MICRA-K11-MARCH-93-03-/170538409062?pt=AU_Car_Parts_Accessories&hash=item27b4e19c66 in rubbers the same.I think labour was $40 to remove old ball joint and press new one in. But I had taken off car...
  17. C

    Micra Comp Truck PT.1

    So what to call it...Micro Monster Truck ?
  18. C

    Soft Clutch Bite

    + 1 Mike I think you've got it.
  19. C

    WTB/info about Headers

    What kind did you buy ? Rang Liverpool Ex. ..Woohoo Is right they now make ones for A/c ..quoted $350 hope they put a better welder on the job .
  20. C

    Soft Clutch Bite

    Maybe needs a little adjusting ?
Back
Top