Search results

  1. emmet_gti

    burning ignition!!

    the back barrel on a march is different to a micra i think because it has 2 screws, ill get one out of the scrap yard down the road its handier cause im in ireland
  2. emmet_gti

    burning ignition!!

    ok as some of you may know i was having trouble starting my march, it starts if i have the ignition on and i run a wire from battery positive to a 10mm nut on the starter. While the car was running i tried turning the ignition to engage the starter, usually on a normal car it would make a...
  3. emmet_gti

    Cg engine swap

    parts from a car 1995 or under for the loom anyway
  4. emmet_gti

    Worn keys!

    if you get nearly any nissan key it will start your car as most likely the ignition is worn alot too, once you keep the chip near the ring:p
  5. emmet_gti

    non starting

    im not 100 percent sure but i think the fuel pump relay in down by your right foot behind the panel to the right
  6. emmet_gti

    k11 march help needed !!!

    the problem was the original starter i had in my car it didnt have a 10mm nut on it:) i didnt check because my multimeter is faulty, but i think thats because of the nearly flat battery in it, it mustnt be getting any power
  7. emmet_gti

    k11 march help needed !!!

    starter works fine when i run a wire to the 10mm nut on the starter
  8. emmet_gti

    k11 march help needed !!!

    right, ok well is there any other fuses around the car that i can check or i might have to change the loom!!!
  9. emmet_gti

    k11 loom and ecu into k10. pinout help please :)

    yeah i just asked for it incase i need it
  10. emmet_gti

    k11 loom and ecu into k10. pinout help please :)

    can u email me the wiring diagram for pre nats too frank [email protected] thanks
  11. emmet_gti

    k11 march help needed !!!

    i know the 3 relays click together but could you tell me if the black one beside the blank one does anything?
  12. emmet_gti

    k11 march help needed !!!

    thats were i just put mine
  13. emmet_gti

    k11 march help needed !!!

    right, so the earth from the battery touches the starter using one of the bolts? i put an the earth on the starter and it made no dif
  14. emmet_gti

    k11 march help needed !!!

    Today i hot wired the starter ive used a different starter as mine had no 10mm piece so i couldnt use it to hotwire, i ran a wire to the starter from the battery with the ignition on and the car started, but then i noticed that the earth on the starter motor i think(little spade connector) didnt...
  15. emmet_gti

    17volts from the alternator?

    i havent lost anything yet, but thats because i have to push start the car everytime so i dont start it that often
  16. emmet_gti

    17volts from the alternator?

    13-14 volts
  17. emmet_gti

    17volts from the alternator?

    it reads the same with a battery
  18. emmet_gti

    17volts from the alternator?

    earlier on i push started my car and i took out the battery i measured th voltage acroos the terminals and its 17volts and that was with headlights hazard lights and rear demistor on, is this the reason my distributor stopped working all of a sudden? also with the car running i tried to...
  19. emmet_gti

    neutral switch?

    ok thanks i just dont no whats wrong, yes can u take a picture baguete?
  20. emmet_gti

    neutral switch?

    does my march 1.3 have a neutral switch? could this be the reason it wont start?
Back
Top