Search results

  1. C

    fuel light always on

    the moisture type low fuel sensor is directly wired to the dash light. try unplugging the fuel sender plug on top of the fuel tank whilst IGN on and if the lamp turns off the sensor is stuck on.
  2. C

    K11 common faults? Looking to buy soon.

    heres afew links http://micra.com.au/technical-articles/nissan-micra-common-faults.php http://micra.com.au/technical-articles/buyer-beware.php http://www.micra.org.uk/threads/what-should-you-watch-for-when-buying.53060/#post-543294
  3. C

    Super S ABS driveshafts/CV joints

    only difference between an ABS and nonABS CV joint is the machined edge to tolerance fit the ABS sensor ring. here I was replacing my rear ABS hub (£100 for a new ABS hub) by getting a £30 standard hub machined http://micra.org.uk/threads/pollymobiles-rebuild.35251/page-2#post-387204
  4. C

    How do you change a k11 gear box??

    I drain the gear oil, remove speedo cable, disconnect clutch cable, disconnect wires, remove driveshafts, support the engine wedging block of wood between sump and centre beam, remove the rear engine mount, remove gearbox mount, unbolt gearbox from engine. then i made this balancing hook...
  5. C

    EXPERT ADVICE NEEDED

    http://www.micra.org.uk/threads/uk-micra-brochure-oct-1997.38297/
  6. C

    Won\'t rev past 3K

    btw that loose hose is the gearbox housing breather pipe
  7. C

    Won\'t rev past 3K

    Double check all ur solderings not missing or shorted. I once missed soldering one of the terminals properly, ecu couldn't read the maf so went into limp mode n limited rev to 3k
  8. C

    Rattling Tailgate...

    my boot lock barrel linkage rod also made an annoying loose rattle, removed it
  9. C

    my facelift k11 turbo build thread

    U tried disconnecting the speed sensor wire between the speedo n ecu? Cos that makes the stock map lean out in 4-5th gear for some reason when on a certain rpm and speed combo
  10. C

    Another coilover alternative

    and this is what the bc v1 va coilovers look like for the k11 http://micra.org.uk/threads/pollymobiles-rebuild.35251/page-12#post-422090
  11. C

    WTB Rear disc brake flex hose

    or if ya wanna upgrade to braided lines try hose solutions UK http://www.hosesolutions.org.uk/index.php?main_page=product_info&cPath=355_866_877&products_id=20496
  12. C

    WTB Rear disc brake flex hose

    brakes international in UK?
  13. C

    K11 ABS Light is on?

    check page 2 post 63 of my blog http://micra.org.uk/threads/pollymobiles-rebuild.35251/page-2#post-383958
  14. C

    Stock bush removal

    check page 50 post 2467 of my blog on how i fitted my PU bushes http://micra.org.uk/threads/pollymobiles-rebuild.35251/page-50#post-509593
  15. C

    Front brake pin bolts

    is it the bolt that holds the caliper to the sliding guide pins? how bout going to a fastenings place and find a bolt with similar pitch & length?
  16. C

    Front brake pin bolts

    brakes international?
  17. C

    not fully warmed...no idle

    I'd say from experience its its a common problem caused by series of events: 1. old seized coldstart waxstat mechanism stuck in fast idle mode when warmed up so... 2. idle speed bleed screw is usually tightened too much to compensate, which makes it cold idle or coasting down in neutral rev too...
  18. C

    MickB Micra

    ;)
  19. C

    MickB Micra

    hey Mick & SSUK I only just noticed this thread tday and shoulda known way back :/ soz anyway. yeah my gripper diff that matt humphris sent was originally a 2-way 45/45 single sided clutchpack with speedo and high preload. running PAS helps. when i first ran it, it was soo aggressive on road...
  20. C

    changing gear box oil

    ur welcome
Back
Top