Seb_'s latest activity

2025-09-06 Print Stronger HT Lead Clips The previous thin lead clips were getting loose with the heat 🫣 Designed a thicker &...

Thanks for your support Micra Paul :) Always something new to learn when you're curious enough :unsure:😁 yup cheepaschips ftw (y)

2025-09-03 New Fake Makita 9Ah Battery Ordered a new 9ah 162W/h battery off ebay and hmm it's abit smaller than my old 9ah one? either...

These Denso K16TT are just regular cheap nickel coated electrodes with a thinner double-pertruding tip design (smaller area might've...

Ah I should've checked with the nissan4u OEM charts first which shows the factory spark plugs are indeed NGK BKR4E-11 / BKR5E-11 /...

2025-09-02 Test Headunit Max Volume vs Frequency To test how the equaliser setting & input voltage affects the max vol level just...

2025-09-01 Check Brake Wear Discs are wearing smooth & evenly All the pads wearing evenly, front inner pad has a slight lip Front...

The "switched 12v feed" for the headunit, which has to run through the IGN switch & immobiliser & extra crimps, seems to get only 13.67v...

2025-08-31 Test Sony Headunit RMS Voltages Since the last time I tested the Sony headunits speaker output in June 2020, I've improved...

2025-08-31 Replace Fuel Hose I was watching this video about E10 and poor quality modern cheap fuel hoses degrading/cracking, reminding...

2025-08-29 Print HT Lead Clips These HT lead supports I printed 10yrs ago are starting to warp & crack from all the heat & clamping...

Printed some blue clips the next day to contrast the red engine bay Might as well include the rainbow too lol 😅

Success!!! That last hidden bolt was the key. Once loosened the new belt was on within 5 minutes. Thanks again Frank and 1275. I'm...

With the pushrod shortened by 5mm, I bled the brakes again, started the car with wheels lifted, pump the brake pedal few times...

Managed to find an M6 screw of the correct length Pushrod sits at the right spot where the CAD model says Machined a deeper...