Recent content by jonot2008

hi frank, been thinking about this the last couple of days, the thing is, i think the shafts will be the wrong size as the micra engine will probably be more to one side than where the mini engine was, so one shaft will be too small and the other too long! i know l jones another guy here and...

ahh I seeee.. so would I just take the spider out of the inner cv of micra then put it on the end of mini shaft and what, just run a bead of weld all the way around it? because I don't think the mini shaft will go into it so it would be on the very tip of the shaft? also I thought you couldn't...

ah ok, and spider? sorry whats that lol. only problem is the mini shafts are fatter than the facelift shafts! so would need to get them machined down.

oh are they? what about the inner cv splines? like where the shaft goes. so is there no way to use 1.0 pre face shafts with a 1.3? thanks again

Hi, just signed up to this forum as I am in the process of a cg13 swap into my Austin mini Basically I have a cg13 and g/b and shafts, the outer side of the shaft has 22 splines. BUT mini outer cv's have 19 splines, I read that the 1.0 pre 98 micra shafts had 19 just like the mini and...