1275's latest activity

2025-06-26 Inspect Fuel Tank for Debris So I swapped to a clean facelift tank since March 2024 Changed to a stainless filler pipe in...

Attached brakes & aligned the wheels Printed this cover to protect the exposed adjustable trailing arms from rust Going for a...

2025-06-24 Install New Rear Axle Had to trim the inside lip off these spring cusions so that the spring doesn't jam on the spring seat...

Axle overhauled & ready to reinstall :cool: 👌

Wirebrushed & cleaned the light surface rust off all the parts Applied the initial layer of Jomastic epoxy primer followed by a...

2025-06-21 Make Rose Jointed Panhard Rod Welded the nuts onto the new steel pipe Attached the rose joints Machined this tapered...

2025-06-21 Weld New Panhard Rod Mount I was waiting on this ebay M16 bolt for the panhard mount but realised it's coming from china &...

2025-06-19 Wirebrush Rear Axle Managed to pry the RH spring off & snapped the rest of the panhard mount off 🙈 Wirebrushed as much...

2025-06-05 Remove Rear Axle The rear axle was starting to get abit crusty and needs repainting 🙈 First I removed the brakes, the inner...

2025-05-27 Reroute Front Breather Pipe The front crankcase hose is at a tight angle making the route for future catch cans a little...

Thanks 1275, much appreciated. I have seen similar videos on YouTube but I wanted to know the material of the back plate on the Fonos...

Similar to this I imagine, no idea if you'll find this helpful or not

The completely solid front upper & lower mount (on right) with firm rear mount and OEM left & right mounts was still transferring abit...

Yeah good enough compromise for a smooth comfy drive. Fitting my PTFE manifold gasket & removing the TB coolant lines made a huge...

The standard front mount has soo much slack upto 11mm that I could noticeably rock the engine back/forth & see the softer left & right...